MAHA FWT 1 Euro, Operation & Maintenance Manual

Page: 17 / 134

Eurosystem / Profi-LON Safety
2.2 D1 E101BA1-GB09
2.3 Safety Regulations during Operation
Š
The MAHA test lane Eurosystem may only be used and operated for its intended purpose
and within its stated performance limits.
Š
The MAHA test lane Eurosystem may only be operated by trained, authorized personnel.
The test lane and the surrounding work area must be kept clean.
Š
The test stand must be switched off when not in use and the main switch secured against
tampering with a padlock.
Š
No persons are allowed in the MAHA test lane Eurosystem danger zone. Rotating or moving
parts are dangerous. (e.g. test stand rollers)
Š
In case of emergency turn the main switch (the Emergency-Off switch) to 0.
Š
Running vehicle engines represent potential carbon monoxide poisoning. The
operator/owner is responsible for providing sufficient air ventilation.
2.4 Safety Regulations for Service Work
Š
Service work such as installation, maintenance or repair work on the MAHA test lane
Eurosystem may only be done by MAHA service technicians or authorized service partner
technicians.
Š
All work done on electrical parts of the equipment is to be carried out by trained, qualified
electricians.
1 Before doing any repair / maintenance / set up work turn off the main switch and secure it
against tampering.
2.5 Attention
Š
When the vehicle is on the brake tester roller set with the driven axle, exit the roller set only
when the roller drive is running. Exiting when the roller drive is not on can destroy the electric
motors due to extreme acceleration of the rollers.
Š
Never exit the shock absorber test plates during shock absorber testing. This can lead to
equipment damage.
Š
The brake tester may not be operated without a functioning slip monitoring. Otherwise there
is risk of tyre damage.
Š
Never start a vehicle engine using the roller set drive. This can lead to equipment damage.
Š
No vehicle with a rigid 4-wheel drive may be tested on the brake tester with a standard roller
set. This can lead to damage to both vehicle and test lane. Please ask your MAHA service
representative for more information.
2.6 Further Information
Š
4-wheel drive vehicles cannot be tested using the standard roller set. Erroneous tests will be
the result.
A special 4-wheel drive control is necessary. Please ask your MAHA service representative
for more information.
Š
Avoid unnecessary strain on vehicle and test stand.
Drive the vehicle slowly onto the test stand.
Pay attention that the vehicle has sufficient ground clearance.