Maguire Products GRAVIMETRIC AUGER FEEDER MGF-ST, Instruction Manual

Page: 18 / 47

M A G U I R E P R O D U C T S , I N C .
18
G R A V I M E T R I C A U G E R F E E D E R

Setup – MGF Configuration and System Configuration
Setup is a password protected area of the MGF for making configuration changes.
Setup Menu Navigation and Overview
► Setup (password protected) – Settings and Options Menus
►
MGF Configuration
- MGF specific configuration settings
► Parameters - Controller Operation Parameters - See page 28
► Report Options

PRT – Report Interval (minutes)
► Error Correction

LBE – Lower Boundary Error

UBE – Upper Boundary Error

ATP – Adjustment Trip Point (grams)

ADJ – Adjustment Limit

ECT – Error Count Tracking

RTU – Run-Time Update (seconds)
► Loader Options

LLF – Loader Low Level (grams)

LHF – Loader High Level (grams)

LAT – Loader Alarm Time (seconds)

STL – Settle Time (seconds)
► Alarm Options

LWA – Low Weight Alarm (seconds)

NMA – No Metering Alarm
► Motor Configuration - See page 27

MTF – Motor Factor (grams / revolution)

SPR – Steps per Revolution

RPM – Maximum RPM

PMR – Prime Motor Rate

MTL – Motor Torque Limits
► Load Cell Constants

KDF – Stable Weight

LCZ – Load-cell Zero

LCL – Load-cell Calibration Low

LCH – Load-cell Calibration High

LCT – Load-cell Tolerance
► Weight Settings

BFS – Bin-fill Settle (seconds)

FUL – Full Bin Weight (grams)

NBW – Negative Bin Weight (grams)
► Injection Options

IPC – Injection Color Percent

ISP – Injection Screw Time Percent (percent)

TAT – Target Adjust Threshold (grams/second)
►
Specialized Operations (enable/disable options)

Clear View Totals – Enables Clear button on View Totals screen.

Recipes – Show the Recipes button on Home screen (on/off)

Tag Information – Show the Tag button on Home screen (on/off)

Volumetric – Enable or disable Volumetric Mode. See page 21
►
Manual Operations - Manual operations of devices – Loader, Alarm
►
Calibration Routines – See page 26

Calibrate Motor Rate –Calibration of Flow Rate of Material

Calibrate Voltage – Calibration of Extruder Voltage

Calibrate Load-Cells – Zero and Full Weight Calibration of Load Cells