MT-95 RS-232 HiCo/LoCo Encoder/Reader
8
SETUP - STANDARD MODE
Note
If operating in the 4777 Emulation Mode, refer to Section 6.
When power is applied to the Encoder, the following will be displayed on the LCD:
Please wait during system self test
After a short time, the following will appear (the revision number may be different):
Mag-Tek MT-95
P/N:30060819
Rev:J07
Copyright (c) 2001 Mag-Tek, Inc.
Note
The revision number may be obtained by typing “V” or, when
online, by sending the /V Command.
The part number and revision number are for the EPROM in the encoder.
In the Standalone Mode the main menu will appear:
Select a card operation:
R)ead
C)opy
E)ncode
S)etup
Adjust the LCD intensity as follows: on the left side of the encoder, turn the circular knob by
placing a finger in the depression, and turning the knob clockwise and counterclockwise to adjust
the intensity of the LCD until it is comfortable to read.
For online operation only, if the unit is not properly connected to a PC, the following will appear:
Mag-Tek MT-95
P/N:30060819
Rev:J07
*** OFFLINE ***
Note
In order to perform the setup operation, the unit must be offline or
the keyboard will not be active. The unit is offline when the DTR
signal is inactive (See Appendix A for DTR description).
Recheck the cabling and the serial port selected.
Summary of Contents for 31010019
