MT-95 RS-232 HiCo/LoCo Encoder/Reader
16
Then select
E)ncode
from the following:
Select an operation
Esc=exit
Tk:1* 2* 3*
E)ncode card
C)lear tracks
If all three tracks are encoded, the following display will appear:
Encoding data on tracks 1 2 3
Insert card for encoding
(Auto)
Auto
indicates that the Encoder will encode in either HiCo or LoCo (high coercivity or low
coercivity). Auto is a Mag-Tek proprietary technique that determines if the card is HiCo or
LoCo. Insert the card in the left side, and following will appear:
Encoding data on tracks 1 2 3
-->Slide card right when ready-->
After the card is swiped from left to right, the following sequence may occur:
1.
Encoding data on tracks 1 2 3
<- Slide card left when ready (LoCo)<-
The first attempt is to encode a LoCo card. If the card does not encode at LoCo, there
will be an attempt at HiCo.
2.
This may be a HiCo card. Try again.
-> Slide card right when ready ->
3.
Encoding data on tracks 1 2 3
<- Slide card left when ready (HiCo)
<-
If the card is HiCo and encodes properly, the following will appear:
*** CARD ENCODED CORRECTLY ***
Remove the card
If, at any time during the sequence, the card did not encode properly, the display is as follows:
**Did not encode properly. Try again.**
--> Slide card right when ready -->
Summary of Contents for 31010019
