Magtek 31010019, Installation And Operation Manual

Page: 17 / 54

Section 2. Installation and Setup
9
To setup the Encoder, perform the following steps:
1.
On the keyboard, type
S
. The display will be:
Select option to change Esc=exit
T)racks S)erial E)ncode M)ode C)ard Time
2. Type
T,
and the display will be:
Select tracks to enable Enter=done
Track: 1Y 2Y 3Y A)ll
Type
1,2,
or
3
to toggle each track between
Y
es and
N
o. When
A
is selected, all three
tracks will be set to on (Y). For example, the above display shows all three tracks
enabled. If
1
and
3
are pressed, these two tracks will toggle off, and only Track 2 will be
enabled. Select the tracks to enable and press Enter .
Note
This setup affects card encoding only. During a card read, any
tracks with data will be displayed (and transmitted if online).
3. When Enter is pressed, the program will return to the following display:
Select option to change Esc=exit
T)racks S)erial E)ncode M)ode C)ard Time
Type
S
and the next display will be:
Select online baud rate Enter=done
1=300 2=600 3=1200 4=2400 5=4800 6=9600
The current setting will be indicated by a flashing cursor on one of the numbers. Press 1,
2, 3, 4, 5, or 6 to highlight the baud rate and
Enter to select it. The default is
9600
. The
default parameters are listed in Table 2-1. To retain the
9600
baud rate, press Enter
when
6
is highlighted. If Esc is pressed, the original baud rate will remain in effect.