Magtek 31010019, Installation And Operation Manual

Page: 13 / 54

5
SECTION 2. INSTALLATION AND SETUP
Before installing the Encoder, check the packing slip to ensure the order is correct and all parts
are included. Check for the following:
PARTS REQUIRED
Standard MT-95
•
Model MT-95 RS-232 HiCo Encoder/Reader P/N 31010019
•
Power Cord P/N 71100001 (included)
•
HiCo and LoCo test cards (1 each)
•
Optional Mag-Tek Keyboard, P/N 93600047 (if a PC is to be used, the keyboard is not
required)
•
Optional PC Cable either for DE9P Male Connector P/N 21015823 or for DB25P Male
Connector P/N 21015821 (pin lists are shown in Appendix A)
IntelliCoder
•
Model IntelliCoder, RS-232, HiCo/LoCo Encoder Reader, P/N 31010021
•
Power Cord, P/N 71100001 (included)
•
PC Cable, 9-pin to 9-Pin, P/N21015847 (included)
4777 Emulation MT-95
•
Model MT-95 RS-232 HiCo Encoder/Reader P/N 31010020
•
Power Cord P/N 71100001 (included)
•
HiCo and LoCo test cards (1 each)
•
Cable P/N 21015846 (MT-95 to IBM 4778 PIN-Pad) (included)
HARDWARE INSTALLATION
To install the encoder, perform the following steps in the Standard mode as described below:
Note
See Section 6 for installing the 4777 emulation version.