7
ENGINE SAFETY
Internal combustion engines present special hazards during operation and fueling. Failure to follow the
safety guidelines described below could result in severe injury or death. Read and follow all safety warnings
described in the engine operator’s manual. A copy of this manual is supplied with the unit when it was
shipped from the factory.
•
DO NOT
run engine indoors or in an area with poor ventilation unless exhaust hoses are used. Diesel
engine exhaust contains carbon monoxide, a deadly, odorless and colorless gas which, if inhaled,
can cause nausea, fainting or death. Make sure engine exhaust cannot seep into closed rooms or
ventilation equipment.
•
DO NOT
fill fuel tank near an open flame, while smoking, or while engine is running.
DO NOT
fill tank
in an enclosed area with poor ventilation.
•
DO NOT
operate with the fuel tank cap loose or missing.
•
DO NOT
operate on a combustible surface.
•
DO NOT
touch or lean against hot exhaust pipes or engine block.
•
DO NOT
clean air filter with gasoline or other types of low flash point solvents.
•
DO NOT
remove engine coolant cap while engine is hot.
•
DO NOT
operate the unit without a functional exhaust system. Prolonged exposure to sound levels
in excess of 85 dB(A) can cause permanent hearing loss. Wear hearing protection when working
around a running engine.
•
Keep hands, feet and loose clothing away from moving parts on the pump and engine.
•
Keep area around exhaust pipes and radiator free of debris to reduce the chance of an accidental fire.
•
Batteries contain sulfuric acid, which can cause severe injury or death. Sulfuric acid can cause eye
damage, burn flesh or eat holes in clothing. Protective eye wear and clothing are necessary when
working on or around the battery. Always disconnect the negative
(-) battery cable from the
corresponding terminal before performing any service on the engine or other components.
•
Shut down the engine if any of the following conditions exist during operation:
1.
Noticeable change in engine speed.
2.
Loss of pumping output.
3.
Sparking occurs.
4.
Engine misfires or there is excessive engine or pump vibration or noise.
PUMP SAFETY
Centrifugal pumps are designed for specific applications and may not be suited for other uses without
loss of performance or potential damage to equipment/personnel. If there is any doubt about suitability
for a specific purpose, contact Magnum Power Products LLC for assistance. Follow the safety guidelines
described below to prevent hazardous situations which could result in severe injury or death.
•
This pump is designed to handle mild industrial corrosives, residues and slurries containing large
entrained solids. Do not attempt to pump volatile, corrosive, or flammable materials that may damage
the pump or endanger personnel as a result of pump failure.
•
After the pump has been positioned, make certain that the pump and all hose/piping connections are
tight, properly supported and secure before operation.
•
DO NOT
operate the pump without the guards in place over the rotating parts. Exposed rotating parts
can catch clothing, fingers, or tools, causing severe injury to personnel.
•
DO NOT
remove plates, covers, gauges, pipe plugs, or fittings from an overheated pump. Vapor
pressure within the pump can cause parts to disengage and be ejected with great force. Allow the
pump to cool before servicing.
