Use and installation manual for a MAGNUM sauna stove
16.06.2015 8
Starsauna Oy
Technical support:
Pistotie 4
15860 Hollola, Finland
Section II.4
Timer
You can move from the default mode to the timer by pressing the Menu button
three times in a row. The (+/
˄
) and (–/
˅
) buttons are used to change the timer’s
setting. The adjustment range is 0.5 h – 24 h and the adjustment step is 0.5 h. When
this value is zero, the timer is not in use.
This setting may only be changed when the device is off.
Section II.5
Turning the sauna on
Turn the sauna stove’s power on using the control switch at the lower part of the
sauna stove. Pressing the controller's On/Off button makes the sauna stove start
heating the sauna until the target temperature has been reached. The stove’s
indicator light in the controller will be turned on. The decimal mark lights up on the
lower right side of the screen as a signal of the resistors being on.
(If the timer has been set, the On/Off button turns the timer on and the sauna stove
begins heating only after the timer has run out). The On/Off button turns the sauna
stove off.
Control switch
Tip:
If the timer has been set but the sauna stove is not on, you may override the
timer by pressing the On/Off button and keeping it pressed for a couple of seconds.
This causes the stove to start heating the sauna immediately. The timer’s setting
remains in the memory.
Magnum RC
Finlandia
Basic setting
Time left
Default setting
Time left
When the machine is on, the default mode and the remaining time alternate on the
screen with an interval of approximately 10 seconds.
