Use and installation manual for a MAGNUM sauna stove
16.06.2015 27
Starsauna Oy
Technical support:
Pistotie 4
15860 Hollola, Finland
8. Problems / troubleshooting:
Why is the sauna stove not heating the sauna?
Check the following:
1.
Is the power on?
2.
Is the adjusted temperature higher than the temperature of the sauna?
3.
Has the temperature limiter gone off? (The cause must be determined before the
next use)
4.
Are the fuses intact?
5.
Is there an error code in the control panel display? If the device malfunctions,
the display will show an error code. You may attempt to solve the problem with
the following error codes. If the problem is not solved with these instructions,
contact the technical support or maintenance.
The error codes are removed from the display when the error has been solved, such
as when the sensor's short circuit has been removed or an overheated device has
cooled down sufficiently. After this, you may attempt to turn the device on again.
Error code / symptom:
Legend:
ER1 = There is no heat sensor or the temperature is too low.
Verify the heat sensor's cabling and installation.
ER2 = Heat sensor has short-circuited or the temperature is too
high. Check the heat sensor's cabling and ensure that the sensor is
intact and that there are no short circuits.
The temperature in the device’s control electronics is too high.
See the previous part.
No error codes on the screen, but the
sauna is not heating up
Check the overheating protection and ensure that it has not gone
off. The overheating protection may be turned off by carefully
pressing the button in the heat sensor box.
The stove light does not work
First confirm that the sauna stove's model features the lights. If
the light is not turned on, contact technical support.
The sauna stove does not heat
properly
Contact technical support.
