Note:
Prepare the banknotes to be counted
as shown in
Figure 15
, remove the
banknotes that are torn, wet, grease or
dirty.
Advice:
For customer's convenience
we suggest to use a stylus, a pen-shaped
accessory designed to control the devices with a touch interface. The stylus
will facilitate your work with the counter.
Two styluses for the resistive
touch screens are the part of delivery
set (
see Figure 16
).
13
12
5.
In case of an error, follow the advices of the «
Error Messages
» section.
Figure 15
Figure 16
Setup Menu
To enter the user’s settings menu, press the «
MENU
»
key
(
see Figure 13
).
The user’s settings menu appears on the screen. In its left part, there are
the submenu keys, in the right part there are the corresponding parameters. To
save the changes and exit the menu, press the key. After the exit, the
screen shows the selected settings. To exit the menu without saving the
changes, press the key.
1
Submenu «
COMMON
» (
see Figure 17
).
It includes two categories: «Detection» and «Speed», keys
«
POCKETS’ LIMIT
», «
INFORMATION
», «
FACTORY RESET
» are
also available.
Detection
UV
is ultraviolet detection mode. When it's activated ( ), and a
banknote with an increased UV fluorescence has been found (for example, a
counterfeit printed on plain paper), the banknote goes to the reject pocket (the
rejection causes are available in the «
REPORT
» submenu).
MG
is magnetic features detection. When it's activated ( ), and a
banknote without magnetic marks has been found, the banknote goes to the
reject pocket (the rejection causes are available in the «
REPORT
» submenu
).
DENSITY
is banknote density detection that available only for
COUNT
mode. When it's activated ( ) and a very dark banknote has
been found (or two notes passed together) or a very transparent one, the
banknote goes to the reject pocket (the rejection causes are available in the
«
REPORT
» submenu)
.
Figure 17
Speed
User can choose any of four counting speeds (600, 900, 1200, and 1500
banknotes per minute). The check-box opposite the selected speed is
highlighted in blue. For counting of worn notes we suggest low speed (600 or
900 notes/min).
Attention
: if
UV
detection
is activated
( ), only two counting
speeds (600 and 900 notes/min) are available.
Information
This screen is contained the info on the device identifier (UIN), the firmware
(FW) versions, the supported languages, the supported currencies, and the
currency database version (
see Figure 18, Figure 19
). To view the text given
below, move your finger across the screen from the bottom upwards and for
the text above - from the top downwards.
MAGNER PRB VALUE COUNTER
MAGNER PRB VALUE COUNTER
