41
40
TROUBLESHOOTING
Table 4
The counter fails
to switch on
Make sure about the counter connection to the
power supply and the power cord plugging into
the connector on the back of the machine.
Make sure that the power switch is in position
«I».
If these terms are observed but the machine
still fails to switch on, call the technician
Failure
Elimination method
The display shows the
message not described in
the «Error Messages» table
Switch off the counter and then switch it on. if
the counter still doesn't work, call the
technician.
An abnormal noise
level or foreign sounds
inside the machine
Switch off the machine. Call the technician.
TRANSPORTATION AND STORAGE
The machine in the original package can be shipped by sea (in containers),
by railway (in closed wagons), by air (in the pressurized modules) and by cargo
(in covered truck or in container with water-resistant top) along the paved
roads. The transportation conditions: temperature - 30 to + 50°C, relative
humidity up to 98% without water condensation at 25°C and atmosphere
pressure 84 to 107 kPa (630 to 800 mm Hg).
The machine in the original package can be stored in a heated and
ventilated warehouse, at the temperature of +5°C to +40°C and a relative
humidity not exceeding 80% at +25°C. A warehouse should be free of the
agressive agents (acid and alkali vapors) that might cause corrosion.
Figure 54
4
Use the mouse left button to select the connected counter, and press
the «
Update device firmware
» key (
see Figure 54
), the process of
upgrading starts, and the progress bar is appeared in the
Update
column
(
see Figure 55
). The progress bar will also appeared on the
screen of the counter.
Attention!
Do not disconnect USB cable from the counter, do not
switch off the counter, and do not disconnect the power cord
during upgrading
.
EBKM.COM
MPRB
MPRB
It may cause serious injury of the counter and make impossible the
further updates outside your supplier's workshop.
Figure 55
MPRB
MPRB
EBKM.COM
MAGNER PRB VALUE COUNTER
MAGNER PRB VALUE COUNTER
