EN
24
www.magmaweld.com
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
monoTIG 220ip / 220ipw / 220ip AC-DC / 220ipw AC-DC
4- Trigger Modes / Hot Start - Arc Force Selection
You can switch between 2/4 trigger and Spot modes with the touch-sensitive button while the
TIG modes are selected you can also change Hot Start and Arc Force settings while the electrode
modes are selected.
Ht
Machine provides up to 2 times higher current than main current for easy ignition.
• Hot Start will be set between 0-100% with the help of the current adjustment pot.
• If set to 0, it does not add any value on the main current at the first ignition, if set to 100
it adds a value increased by 100% on the main current.
• In miliseconds it reduces the amperese to main welding current.
• Factory setting is 20 %.
Ar
When welding the electrode, it prevents the arc interruption by increasing the current up
to twice the main welding current in case the arc tends to interrupt.
• Arc Force is between 0-100 %.
• Arc Force prevents the electrode from sticking by adjusting the current when the
electrode tends to stick.
• The default factory setting is 20 %.
In 2-Trigger mode;
• Welding starts when the trigger is pressed, pre-gas is supplied ignites at minimum
current, makes the launch ramp and continues welding in main current.
• When the trigger is released, it makes the end ramp, fills the crater in the crater filling
current, makes the final gas time and completes the welding.
Press the Trigger
Hold the Trigger Pressed
Release Trigger
3- Welding Method Selection
You can choose between electrode types and TIG welding methods with the touch sensitive button.
The led of the relevant parameter will light up depending on which welding method is selected.
Allows welding with cellulosic electrodes.
Allows welding with rutile and basic electrodes.
NOTE
In electrode modes, current adjustment will be between 3 and 180 A. VRD mode will be
active in electrode modes. In electrode modes, the TIG Curve will not be active.
The current adjustment will be between 3 and 220 A in TIG Modes. The TIG curve will be
active when TIG modes are selected.
Allows DC TIG welding.
Allows AC TIG welding.
Operation
