Magmaweld ID 300 E, User Manual

Page: 10 / 68

EN
10
www.magmaweld.com
ID 300 E
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
TECHNICAL INFORMATION
1.1 General Information
Figure 1 : ID 300 E
1-
Mains Cabla Inlet
7-
Current Adjustment Knob
2-
ON / OFF Switch
8-
Current Display
3-
Remote Control Connector Inlet
9-
Voltage Display
4-
Earth Cable and Welding Cable Socket (+)
10-
Hot Start Adjustment Knob
5-
Earth Cable and Welding Cable Socket (-)
11-
Arc Force Adjustment Knob
6-
Handle
12-
Welding Mode Selection Button
ID 300 E is an inverter type portable, tri-phase (400VAC 50-60Hz) DC MMA welding machine designed to
weld stick electrodes up to 5.0 mm designed regarding for the related phase-notr voltage. Must be used at
3 phase, 4 wire and notr grounded systems. Due to descending characteristics of the inverter technology it
provides stable arc and good re-striking performance. Initial striking ability of the electrodes can be
improved via Hot Start potentiometer and certain electrodes like basic electrodes which have tendency to
short circuit and stick to the weld pool could be avoided by adjusting the Arc Force potentiometer.
It can be used as a Touch-Scratch DC TIG welder if a TIG torch with a valve is connected.
The electric consumption is approximately 10% less than the silicon controlled rectifier equipments and
25% less than the magnetically controlled equipments.
ID 300 E can also be used with long welding cables up to 25 m.
Plus, wireless and cable remote control options are possible.
The machine is fan cooled and thermally protected against over heating.
1.2 Machine Components
Technical Information