Magmaweld ID 300 E, User Manual

Page: 19 / 68

EN
19
www.magmaweld.com
ID 300 E
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
4.2 Error Codes
It gives an error message when the mains voltage is wrong or thermal. If you do not want the welding
performance to be affected during installation, the parameters such as wire diameter, torch, consumables
used in the torch, wire type, wire diameter and gas type should be considered.
ERR-T1 Thermal Error
• Let the machine on for a while in
order to cool down itself with the
cooling fan. After is cools enough,
you can go on welding
• Machine is overheated because of
high ambient temperature of
exceeding duty cycle
• Error/Errors may exist in any
electronic card
• Switch off and switch on. If the
error still exists, check the mains
voltage whether it is within the
range of 340V-420V or not. If the
error still exists, contact the
authorized service
E2
Power Module
Error
Error Code Error Reason Solution
• Check the electronic card and
mains voltage. If the voltages are
normal, contact the authorized
service
• Check the mains voltage. If the
mains voltage is normal, contact
the authorized service
• Check the electronic card and
mains voltage. If the voltages are
normal, contact the authorized
service
• Check the mains voltage. If the
mains voltage is normal, contact
the authorized service
• Electronic card or network
voltage drop can
• There may be a drop in mains
voltage
• Electronic card or mains voltage
there may be a rise
• There may be an increase in
mains voltage
E4
E16
Electronic
Card or Mains
Voltage High
Low Mains
Voltage
E8
E32
Electronic
Card or Mains
Voltage Low
High Mains
Voltage
Maintenance and Service