Magmaweld ID 300 E, User Manual

Page: 18 / 68

EN
18
www.magmaweld.com
ID 300 E
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Strictly follow the instructions contained in safety rules while servicing the machine.
• Before removing any screw on the machine for maintenance, power supply must be disconnected from
the electric lines and enough time should be allowed for capacitor discharging.
• Do not remove the warning labels on the device. Replace the worn/torn labels
with the new ones. Labels can be obtained from the authorized service.
• Check your clamps and cambles. Pay attention to the connections and the
durableness of the parts. Replace the damaged/defective parts with the new ones.
Do not ever make aditions to/repair the cables.
• The Wire Feeding Mechanism must be kept clean and the roller surfaces must not
be lubricated.
• Always remove any deposits on the mechanism with dry air each time you replace
a welding wire.
• The consumables on the torch should be cleaned regularly. It should be replaced if
necessary. Make sure that these materials are original products for long-term use.
4.1 Maintenance
4.2 Non-Periodic Maintenance
Every 3 Months
• Clean and tighten fasteners such as bolts and nuts.
• Check the electrode clamp and grounding clamp cables.
• Open the side covers of the machine and clean with low pressure dry air. Do not
apply compressed air to electronic components at close distance
Every 6 Months
Never operate the machine when covers are open.
Maintenance and Service
MAINTENANCE AND SERVICE
or
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are
encountered in your device. Depending on the work load and contamination of your work environment,
you can repeat the above processes more frequently.