Magliner LiftPlus, Maintenance Manual

Page: 7 / 40

1-800-MAGLINE (624-5463)
Lift Plus
®
7
LIFT SCREW GIRDLE AND UPPER BELT
TOOLS NEEDED: NEEDLE-NOSED PLIERS OR E-RING TOOL; LARGE FLAT SCREWDRIVER; DEAD-BLOW
HAMMER
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove motor and top covers.
3. Remove the E-rings from the top of the Pulley shaft and lift screw
4. Remove the lift screw girdle. If necessary insert a large flat blade screwdriver between the lift screw girdle and
the top of either Pulley and gently twist.
5. Remove the upper belt by lifting it over the top of Pulley 2-3 while slowly turning Pulley 1 by hand.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Wrap the upper belt around Pulley 4 and stretch it just over the top of Pulley 2-3.
3. Press the belt down over Pulley 2-3 while turning Pulley 1 by hand.
4. Install the lift screw girdle, tapping gently with a dead-blow hammer if necessary.
5. Connect the battery unless other work on the lift drive system is planned.
REPLACING LOWER BELT
TOOLS NEEDED: NONE
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the lift screw girdle and upper belt.
3. Lift the Lower Belt over the top of Pulley 1 while slowly rotating Pulley 1.
4. Slide the lower belt out between Pulley 2-3 and Pully 4
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Slide the lower belt in between Pulley 2-3 and Pulley 4.
3. Wrap the lower belt around the bottom of Pulley 2-3 and stretch it just over the top of Pulley 1.
4. Press the belt down over Pulley 1, while hand turning Pulley 1.
5. Install the lift screw girdle and upper belt.
6. Connect the battery unless other work on the lift drive system is planned.