1-800-MAGLINE
(624-5463)
Lift
Plus
®
13
LOWER LIFT SCREW COLLAR
TOOLS NEEDED: NEEDLE-NOSE PLIERS OR E-RING TOOL
Removal:
1. Drive the quick change latch to its lowest position.
2. Turn off the LiftPlus and fold the unit.
3. Remove the retaining ring on the clevis pin, then the clevis pin from the lower lift screw collar.
4. Slide the collar off of the lift screw.
Installation:
1. Slide the lower lift screw collar
2. Install the clevis pin and retaining ring.
3. Unfold and lock the LiftPlus.
LOWER LIFT SCREW ASSEMBLY
TOOLS NEEDED: NONE
Removal:
1. Remove the lower lift screw collar.
2. Disconnect the battery.
3. Unfold and lock the LiftPlus
4. Remove lift screw girdle and upper belt.
5. Hand-turn Pulley 4 counterclockwise until lift screw is free of trolley drive nut.
6. Pull lift screw assembly up and out of the column. It may be necessary to tap the bottom of the lift screw with a
hammer to free the assembly from the column.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Slide the lift screw assembly down into the plastic guide in the column.
3. Hand turn Pulley 4 clockwise until the trolley begins to lift the platform.
4. Align the lift screw guide bushing with the opening at the top of the column and press it in. A dead-blow ham-
mer may used on the top of the lift screw, but be sure that the bushing is correctly aligned before every blow.
5. Install the lift screw girdle and upper belt.
6. Check to be sure that the guide has not slid out of the bottom of the column. If it has it must be slid back and
held in place by hand to avoid damage while folding the LiftPlus.
7. Fold the LiftPlus
8. Install the lower lift screw collar.
9. Connect the battery unless other work on the lift drive system is planned.
10. Unfold and lock the LiftPlus.
Pulley 4
TOOLS NEEDED: 1-2 LBS. HAMMER, 3/16” PIN PUNCH
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Slide Pulley 4 onto the lift screw.
3. Carefully align the holes in the lift screw and Pulley 4 so that both are vertical.
4. Push a 3/16” by 1.625” long split roll pin into the top of the slot in Pulley 4.
5.
Place the lift screw assembly on a hard, flat, and stable surface with Pulley 4 protruding just past the edge.
<OR>
Place the lift screw assembly on the floor with a block supporting the lift screw just below Pulley 4.