1-800-MAGLINE (624-5463)
Page 51 www.magliner.com
CooLift
®
Figure 4
Figure 5
4. Slide the latching section of the new pawl assembly in place as shown in Figure 4. Install the latching
section in place and secure it using lock washers (F,G) and blue thread locker, applied 3/16” to 5/16”
from the head and end of the screw. Note: A small pin or drill bit can be used to align the latch block
with the master cylinder holes.
5. After the installation is complete, engage the holding brake and release it a few times to insure it is
working properly.
A
RELOCATING MASTER CYLINDER
TOOLS NEEDED:
TORX T30 WRENCH
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface.
2) Loosen the two screws that hold the master cylinder to the horizontal brace using the T30 wrench.
3) Loosen the top jam nut on the cord grip if more brake line needs to be released from the inside of the
cabinet and retighten after repositioning.
4) The master cylinder can now be slid into another location. NOTE: Keep the master cylinder upright during
this process to keep from introducing air into the brake system.
5) Tighten the screws to secure the master cylinder in the new location.
FASTENING SCREWS
JAM NUT
