1-800-MAGLINE (624-5463)
Page 14 www.magliner.com
CooLift
®
REPLACING BRUSHES
TOOLS NEEDED:
FLAT HEAD SCREWDRIVER, #3 PHILLIPS SCREWDRIVER, PAIR OF PLIERS
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface.
2) Engage the holding brake.
3)
Turn off main power switch.
4) Remove the back access panel from the cart.
5)
Insert the flat head screwdriver into end of the slotted frame that holds the brush section and bend
the end of the slot open enough to allow the old sections to slide out
(A, B).
6) Remove the old brush sections using the pliers to grab them and slide them out of the slots.
7) Slide in the new brush sections (A, B) into place.
8) Using the pliers, re-crimp the ends of the slots to enable the brush sections to remain in place.
9) Place the back access panel back into position and secure with the latches.
Item
Qty Part Number
A Yoke brush
1
309257
B Back panel brush
1
309259
B
A
