1-800-MAGLINE (624-5463)
Page 10 www.magliner.com
CooLift
®
CPA48 BULK HEAD REMOVAL
TOOLS NEEDED:
7/16” WRENCH, 1/2” SOCKET END WRENCH, #3 PHILLIPS SCREWDRIVER, TWO 9/16”
WRENCHES, SPACER BLOCK (4” x 4” x 24” WOODEN BLOCK)
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface with the holding brake engaged.
2) Raise the deck to the highest position.
3) Place a spacer block between the deck and the base of the cart.
4)
Turn off main power switch.
5) Remove the two screws (I) and lock nuts (F) that attach the bulk head (A) to the base plate using
the 1/2” socket end wrench.
6) Take out the four screws (G) and lock nuts (H) that attach the bulk head saddle plate (B) and the
containment strap assembly and spacer (C, D) to the bulk head and the main cart using the #3
Phillips screwdriver and the 7/16” wrench.
NOTE: If the bulk head is going to be reinstalled after servicing, only the two screws (G)
anchored to the main cart and the saddle plate need to be removed. If the bulk head is
taken off and the CooLift will be used in the 53” pallet configuration, a new saddle plate
(309151) will need to be installed.
7) Lift and remove the saddle plate. Then lift and remove the bulk head frame to disengage from the
base plate.
CPA48 BULK HEAD INSTALLATION
TOOLS NEEDED:
7/16” WRENCH, 1/2” SOCKET END WRENCH, #3 PHILLIPS SCREWDRIVER, TWO 9/16”
WRENCHES, SPACER BLOCK (4” x 4” x 24” WOODEN BLOCK)
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface with the holding brake engaged.
2)
Turn off main power switch.
3) Slide the bulk head (A) into position on the base plate in the location shown in Figure 2.
4)
Fasten in place using the two screws (I) and lock nuts (F) and finger tighten (the screw heads will
be on top of the base plate and the lock nuts underneath).
5) Place the bulk head saddle plate (B) into position and attach using the four 1/4”-20 x 2-3/4” long
screws (G) and 1/4”-20 lock nuts (H) and finger tighten.
6) Place the containment strap mounting spacer (D) onto the bulk head saddle plate and then place
the containment strap assembly (C) onto the mounting spacer. Insert one 3/8”-16 x 1-1/2” long
screw (E) and 3/8”-16 lock nut (F) and securely tighten using the two 9/16” wrenches.
7) Once all items are in place, securely tighten the hardware for the bulk head saddle plate and for
the hardware connecting the bulk head to the base plate
