Magio MG-968, Instruction Manual

Page: 24 / 26

24
Automatic interruption of work and disconnection from the network can happen in
case if all water will boil away. The display will show “ ” mark accompanied by a
«beep» sound.
The reasons of automatic interruption:
- the appliance is plugged in but it is empty;
- the water level is below the «MIN» mark during boiling;
- all water has boiled away and it is needed to add more;
- the lid is not locked;
- hot water was added after plugging in the device.
1. Press the re-boiling button (page 22) one time. Re-boiling indicator will
light up.
2. After water has boiled keep warm indicator will light up.
T here are three types of water dispense:
1. Hand pump dispenser.
- On the upper lid, switch the hand pump lock (10) to the “unlock” position.
- Place the cup to be filled under the water spout (11).
- Then press down on the water pump lid (1) to pour water.
2. Automatic pump dispenser.
- Press the «Unlock button» (page 22) one time. The unlock indicator will light up.
- Place the cup under the water spout (11).
- Press «Dispense button» (page 22) to pour water.
3. Cup trigger dispenser.
- Press the «Unlock button» (page 22) one time. The unlock indicator will light up.
- Place the cup under the water spout (11).
- Holding the cup under the water spout (11), press it on the cup trigger dispenser
(8) by a cup.
If the automatic interruprion function happened, unplug the device and let
it cool down. Then add water and turn it on again.
Note
Re-boiling function
Water dispensing
The re-boiling function will not work if water is not enough.
Pressing the Re-boiling button immediately after the water has boiled will not
work because the water temperature has already reached 100 °C.
Work interruption function
EN
Hand pump water dispenser does not require the appliance must be
connected to the network.
Note