5
AFTER SALES SUPPORT
AUS
1800 623 432
MODEL: IPC-100 AC
PRODUCT CODE: 91838
12/2014
Only use the supplied power supply or a power supply with the same specifications. Only connect the power supply to a
power supply corresponding with the ratings on the rating plate.
Damaged power supplies or output cables may not be used. Replace it with a power supply of the same type.
Ensure that all sockets used are always freely accessible so that the power supply can be quickly disconnected, when
necessary. Disconnect from mains only by pulling out plug from mains socket.
Ensure adequate ventilation and do not cover power supply to prevent overheating.
The power supply may not be used during a
thunderstorm
. Otherwise danger of electrocution.
Damage from heat – fire hazard
Do not leave camera in places that are susceptible to considerable increases in temperature
(e.g. a vehicle). The
housing and internal parts may be damaged, which in turn could cause a fire.
Do not wrap up camera or place on textiles.
This could produce a build up of heat in the camera that can cause
deformation of the housing and may represent a fire hazard.
Injuries and material damage
When installing and assembling the camera ensure that a 10 cm gap is maintained on all sides in order to provide
adequate ventilation. Ensure, in particular, that ventilation slots are not covered by newspaper, table clothes or curtains.
Never place open fire sources
on or near the camera.
Damage to the electronics, lens or accessory caused by external influences
such as impacts, falls or others
are not
covered by the warranty and are chargeable.