Magigoo Coater, User Manual

Page: 14 / 24

Magigoo Coater User Manual 14
3.1.4
Preparing for first use
Find a surface that can be easily cleaned.
For the first time use, the Coater system needs to be primed by pumping several times until
the glue starts coming out of the valves consistently. You should see 13 glue dots form on the
surface. Clean the Coater thin film applicator and the valves after priming.
3.2 Recommendations for use
3.2.1 Before Coating
Prepare the build plate area where to apply the adhesive.
- The build plate area has to be thoroughly cleaned.
- The build plate area has to be well levelled.
- Any imperfection on the applied area may decrease the consistency of the applied coating
of adhesive.
How to clean build plate:
Fill the provided spare bottle with water and attach spray head. If possible, remove the bed
from the 3D printer for cleaning. Clean only when 3D printer is not operational and build plate
is at room temperature. If there are solid debris, use plastic scraper to remove. Spray water
on build plate or used Magigoo layer. Clean off with the cloth.
The build surface
has to be very
clean. Any debris
or uneven surface
will disrupt the
application of an
even thin coating.
! !
Do not use hot
water. Boiling or
hot water may
damage the
bottle for water
or the applicator
system.