Magiglo ARIA, User, Installation & Servicing Instructions

Page: 37 / 56

Page 33
3.8.5.
49B
Continuation of Installation - Remote Control Model
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Feed the cable from the receiver unit
heat shield to the spade terminals on the
control valve, keeping the cable clear of
the underside of the tray. The cable
connectors must be matched to the
appropriately sized spade connector.
4. Position the receiver under the heat
shield as shown in
X
Figure 51
X
.
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (
Section
X
2.1.3
X
-
X
Lighting
Procedure (Remote Control)
X
on page
X
8
X
).
6. Proceed to Section
X
3.8.9
X
to commission
the installation.
TR AY
FIXING
SCREW
TRAY
FIXING
SCR EW
CONTROL
VALVE
GAS IN LET SL OT
C OVER
GAS
INLET
RECEIVER/
BATTERY
PACK
PILOT
FIXING
SCREWS
HEAT
SHIELD
POWER
SUPPLY
PLUGS
GROMMET
PRESS.
TEST
POINT
Figure 51