Magicar M881A, Installation Manual

Page: 32 / 60

32
EN
I. INTRODUCTION
MAGICAR M881AS is a safety device with the highest level of security. Thanks to the
2-way remote with pager you will be immediately informed about possible car intrusion, as
well as the manner of the intrusion even though you are too far from the car to hear the
siren. The biggest advance of the two-way remote control is a possibility to use without
direct view of the car. All the commands you will send will be confirmed by remote.
For even higher security level the car alarm is equipped with a two-digit PIN code for
entering the valet mode.
II. PLACING
When fitting each component consider properly the right place for a microwave interior
sensor (if fitted). Since this sensor is working on magnetic principle, it is very sensitive to a
magnetic field developed in car solenoid relays, which may cause a false alarm. For
example, when checking a car status by the remote controller, parking lights will flash. If
the senso
r is placed too close to the lights’ relay, it may trigger the alarm. Check this
possibility before final fitting of the sensor
Place the
antenna on front or rear window the way that it is not in your view. As an
alternative place you can use the shade on the driver
’s side. The antenna is designed for a
horizontal use. Any other positioning may cause decrease of operation range
Glue the round sticker on the
RPS sensor and, after taking the foil off, place the sensor
on the front window on a visible place, not in the driver’s view. As a part of the RPS there
is a LED diode and a button. The RPS sensitivity level is adjustable on its back side by a
three-position switch.