Magicar M881A, Installation Manual

Page: 41 / 60

41
EN
Programming of security code (1111-9999):
1. Ignition on.
2. Open the door.
3. Push the button on RPS sensor 10 times. At every single click, LED will flash red
once. Intervals between the click/pushes must not be longer than 1.5 sec.
4. Blue LED will start flashing rapidly. If it does not happen, go back to step 1.
5. Push the button on RPS as many times as your first number between 1-9 is. After
each push red LED will flash.
6. After entering the digits, wait until LED will confirm the number by a correspondent
number of blue LED flashes.
7. Blue LED will start flashing rapidly. Push the button on RPS as many times as your
second number between 1-9 is. At each push of the button red LED will flash once.
8. After entering the digits, wait until LED will confirm the number by a correspondent
number of blue LED flashes.
9. Continue by repeating steps 7, 8 for entering the third and fourth number of your
code.
10. After entering the fourth number, lights will flash to confirm that the program code
has been accepted.
Changing PIN code
PIN code is set as the factory default code (11). PIN code must be inserted to enter Valet
mode after turning key on/off 3 times if you have
already selected “PIN code ON” from
optional table.
Procedures of change PIN code from the factory default cod
e 11 to owner’s own code
1. System is disarmed.
2. Maintain the conditions of the trunk and the door being opened.
3. Within 3 sec turn the ignition on/off three times. Lights will flash once. Siren makes
a long beep.
4. Push the button on RPS as many times, as your first number (1-9) is. Intervals
between the click/pushes must not be longer than 1.5 sec.
5. Siren beeps once. Lights will flash once.
6. Push the button on RPS as many times, as your second number (1-9) is.
7. Siren beeps twice. Lights will flash twice.
8. Press button
IV on remote for authentication. Siren beeps three times and lights will
flash three times.
IX. WIRING DIAGRAM FOR DOOR LOCKING SYSTEM