16
If you wish to change the logging interval while you are
logging a line feature, you first need to pause the logging
of the feature:
-
Press MENU, highlight
Pause <line feature name>
and
press ENTER
-
Press MENU again, highlight
Logging Interval
, press
ENTER and set the new logging interval as explained
above.
-
After changing the logging interval, press MENU, high-
light
Resume <line feature name>
and press ENTER. The
receiver will continue to log the feature, but this time
according to the new logging interval.
4. Logging and Describing an Area Feature
Basically, you use the same procedure as when you log a
line feature, especially regarding the need for defining a
logging interval (see 3. above). The only difference
between a line and area feature is that for an area feature,
the first and last position calculated by the receiver are
connected when you close the feature.
Record the attributes of an area feature as you do for a
line feature (see page 14):
-
Select the name of the area feature from the list of
features and press ENTER. MobileMapper Pro starts
logging the area feature.
-
Choose a time-based logging interval (see explanations
given for a line area on page 15). This takes you back
to the Logging screen where the list of attributes for
the feature is displayed
-
Describe each attribute by selecting or entering the
appropriate attribute value for each of them.
Logging screen
This screen displays
the current values of
perimeter and area
measured since you
started logging the fea-
ture (+ number of sat-
ellites and PDOP)