STEP 5
– Repeat steps 2, 3 and 4 for the other half of the brackets. Use the same
hardware configuration for this as you did on the other side of the crossbar. Once
the crossbar is installed, then finish tightening down the bar clamp bolts same as
you did in Step 4.
STEP 6 - Windshield Installation
Once bracket attachment is complete, the windshield attaches to the brackets
with Phillips truss screws, plastic flat washers and rubber washers. Insert all four
screws and washers into the four windshield holes (as shown the diagram at
right) before attaching the windshield onto the MadStad brackets. The rubber
well nuts are flexible and the shield holes are oversized so you can nudge the
shield and screws around to get them into the well nuts. Once that’s done go
ahead and screw the four screws down until they are snug, which means the
screw tip has gone past the back of the well nut, the well nuts have swelled up a
bit and the shield is resting snugly against the brackets.
DO NOT
OVERTIGHTEN!
Over-tightening can damage the rubber well nuts.
