995086
–
Rev B
Page 21 of 32
Refitting / Replacement
Refitting is a reversal of the removal process noting the following points:
•
When refitting the lift tape, ensure that the stitching fold is opposing the face of the black bung.
•
For easier refitment, open up the loop of the tape as shown, this can make it easier for the strap pin to fit
through the tape when inside the hub.
•
When sliding the pin back through the chassis, be careful not to catch the lift tape and cause damage to
its integrity.
•
Inspect the condition of the e-clip, if the clip has been stretched, replace with a new e-clip.
•
Once the pin is pushed back through the chassis, ensure to refit the e-clip. This is done using long nose
pliers.
•
Wind the lift tape around the hub by rotating the hub in an anti-clockwise direction.
•
Pull the lift tape while holding the hub to allow the lift tape to stretch and tighten, then continue to wind
around the hub.
•
Refit the removed components to the portable lift.
