MULTI-CHANNEL ANALOG MIXERS WITH ENHANCED FX, USB RECORDING MODES, AND BLUETOOTH®
31
Phones Knob
This knob is used to adjust the volume at the phones output from (off) to maximum gain (max).
Make sure that this knob is fully off [counter-clockwise] before selecting or adding a new source.
WARNING:
The headphone amp is loud and can cause permanent hearing damage. Even intermediate levels
may be painfully loud with some headphones.
BE CAREFUL!
Always turn the phones level control all the way
down before connecting headphones or pressing a solo switch, or doing anything new that may affect
the headphone volume. Then turn it up slowly as you listen carefully.
Blend Knob
With the adjacent (To Phones / Control Room) switch engaged, this knob sends a blend between all inputs
(except for the 1/8" input) and the USB 1-2 Return to the Phones and Control Room outputs.
As an added bonus, this is all at zero-latency!
Use this knob while recording overdubs alongside a pre-recorded track, for example.
Knob position (L, C, R):
• Full Left – Inputs = Full Volume
USB Return = No Volume
• Center –
Inputs and USB Return = Equal Volume
• Full Right – Inputs = No Volume
USB Return = Full Volume
FX Knob / Fader
Stereo signals come through this FX fader – FX knob on the P
and Pr – and continue on to the main mix fader. They contain the effects’
“wet” signals and are mixed together with the channels’ “dry” original signals.
Turned fully up, it provides 10 dB of additional gain, the “U” mark is unity gain,
and fully down is off.
FX to Sub Switch [Pr]
Fancy yourself adding FX to the sub group in addition to the main mix? Simply engage the 1-2 switch to route FX to subs 1-2.
It is located near the lower-right corner of the FX fader as seen in the Pr FX fader displayed above.
P
Pr
Pr