MULTI-CHANNEL ANALOG MIXERS WITH ENHANCED FX, USB RECORDING MODES, AND BLUETOOTH®
30
FX to Mon Knob [Pr]
These knobs route the effects output to the monitors. Use the mon controls to provide effects to monitors.
Slowly add effects to the monitors by turning the mon knobs clockwise. Use the aux master knobs
(described on the previous page) to monitor the amount sent. The Pr has a single FX to mon knob.
FX Mute Switch
When engaged, the internal effects processor is muted, and its output will not appear on the main mix or monitor mix. If this
switch is not engaged, then the internal effects are set free and may be added as required to the main mix and/or monitor mix.
If this switch is not engaged, then the internal effects may be muted or un-muted with a footswitch [all mixers
except the P].
To Phones / Control Room Switch
By default, the control room and phones jacks output the 2-track LR mix (or soloed channels, if any are engaged).
Push this switch in if you want to interrupt this signal and hear the blended signals instead.
Because there are no control room outputs on the P, there is only a “To Phones” switch.
Control Room Knob [Pr and Pr]
This knob is used to adjust the volume at the control room outputs, from (off) to maximum gain (max).
Make sure that this knob is fully off [counter-clockwise] before selecting or adding a new source.
Because there are no control room outputs on the P, there is no control room knob, either.
Pr
Pr
P