13
2
(1234 or 4-digit
PIN) +
Enter 4-digit PIN for setting
followed by
The panel will display the below image:
3
Press
then
to set
the
ARM
mode
– Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone ON or OFF
– If no number appears, the zone is turned OFF
– The panel will display the below image:
4
Press
to complete the
setting
Confirm the setting and return the panel to
STANDBY
by pressing
h. t
riGGerS
in
arm m
Ode
Example: Zone 1 trigger
Step
Description
Note
1
Under the “
ARM
” Mode
The panel will display the below image:
2
System trigger
One beep indicates that the system is triggered.
3
Entry delay 30 seconds
There are 30 seconds of entry delay time with a visual countdown for disarming.
Once an intrusion has occurred (zone triggered under
ARM
status), the alarm siren
will sound for 1 minute and the panel display flashes RED every 1.5 seconds with the
triggered zone indicated, until the system is disarmed.
*To disarm the system, enter the 4-Digit PIN or press
on the remote control.
4
Return to
ARM
mode after
the initial triggering
After the initial triggering, the alarm will immediately sound, without delay, if any
other sensors are triggered.
3.3.3 alert m
Ode
If in
ALERT
mode, the Wireless Alarm Panel chime will sound and the Wireless Alarm Panel flashes
GREEN every 1.5 seconds with the triggered zone indicated, when the system detects a visitor in the
protected area.
ALERT
mode default settings:
Sensor
Zone
Status (MODE)
• Door/Window Sensor
1
ALERT
• Door/Window Sensor
2
ALERT
• Motion Sensor
8
ALERT
