MacDonald Steel Limited
BREWERY SYSTEMS DIVISION
12
REV 00
MACHINE SETUP
VENT FLOW CONTROLS
These needle valve flow controls are located on the left hand side of the machine, one for each
head. C.W. decreases the flow rate, C.C.W. increases flow. Start about ¼ turn C.C.W from fully
closed. Gradually increase flow, but do not allow foaming during filling.
Flow controls on the DFC4
NOTE
During CIP mode, open these controls fully C.C.W. to allow maximum flow of cleaning
solutions and rinse water.
DRAIN LINES
Attach the plastic drain fittings (
⅛
NPT x ¼ hose barb) to the vent flow controls on the
side of the machine. Using the ¼” hose supplied, cut four lines, one to each of the drain
fittings, run these lines to drain. Do not allow the lines to be submersed in liquid; they
should be vented to atmosphere.
