214657
243
Revision A
Figure 5.175: Left Side Master Cylinder
9.
Cut cable ties on hoses (A) and (B), and disconnect
hoses from cylinder. Install caps onto hose ends or
wrap with plastic.
Installing Master Cylinder
Figure 5.176: Left Side Master Cylinder
1.
Remove the two 90 degree elbows (A) and (B) from
previously removed master cylinder. Refer to
2.
Remove plugs from new master cylinder ports.
3.
Install elbows (A) and (B) onto new master cylinder as
shown. Align elbow (B) as shown (C). Tighten jam nuts
on elbows.
Figure 5.177: Left Side Master Cylinder
4.
Connect hose (A) from slave cylinder to elbow (C) at
rod (aft) end, and hose (B) from header to elbow (D) at
barrel (forward) end. Tighten fittings ensuring hose (B)
is routed parallel to the cylinder.
Summary of Contents for PW8
