262171
244
Revision A
Reversing Header
The header can be reversed using the header drive controls located on the operator
’
s console.
When reversing the header, the following functions will operate in reverse:
•
D1XL Series:
knife
•
D1X Series:
knife
•
D2 SP Series:
knife
•
A40DX:
knife, conditioner, auger, and reel
•
A40DX GSS:
knife, auger, and reel
Reverse the header as follows:
1012982
C
B
A
Figure 5.107: Header Drive Controls
1.
Press and hold HEADER DRIVE REVERSE button (A).
2.
Press and hold HEADER ENGAGE switch (B). Pull up on
collar (C), until switch (B) is in the ENGAGED position.
3.
When you are ready to return to forward operation, release
HEADER DRIVE REVERSE button (A) to stop the header.
4.
Push down HEADER ENGAGE switch (B) to the OFF position.
The header can now be re-engaged. For instructions, refer
to
Engaging and Disengaging the Header, page 243
.
5.4.4
Adjusting Header Angle
Header angle is the angle between the ground and the cutterbar. It is adjustable to accommodate crop conditions and
soil types.
Refer to the appropriate header operator
’
s manual for the range of adjustment and recommended settings for your
particular header.