262171
243
Revision A
1015886
A
Figure 5.105: Header Engage Switch
4.
Disengage the header by pushing down on HEADER
ENGAGE switch (A).
5.
Adjust the float setting for the selected deck position. For
instructions, refer to
.
6.
Repeat the previous steps for the other deck positions.
5.4.3
Header Drive
All header drive controls are located on the operator
’
s console and on the ground speed lever (GSL) handle.
NOTE:
Some controls are optional equipment and may not be present in your unit. Some controls may be installed, but will be
nonfunctional for certain headers.
Engaging and Disengaging the Header
The HEADER ENGAGE switch engages and disengages the header drive.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1.
Start the engine.
10127561012756
A
B
Figure 5.106: Header Engage Switch
2.
To engage the header, push and hold HEADER ENGAGE
switch (A) down while pulling up on collar (B).
To disengage the header, push HEADER ENGAGE
switch (A) down.
