214327
262
Revision B
Problem
Solution
Refer to
Symptom: Reel Motion is Uneven or Stalls in Heavy Crops
Reel speed too fast
Reduce reel speed
Reel fingers not aggressive enough
Move to a more aggressive finger
pitch notch
3.7.12 Reel Tine Pitch, page 68
Reel too low
Raise reel
Relief valve on windrower has low
relief pressure setting
Increase relief pressure to
manufacturer
’
s recommendations
Refer to the windrower
operator
’
s manual
Low oil reservoir level on windrower
(sometimes more than one reservoir)
Fill to proper level
Refer to the windrower
operator
’
s manual
Relief valve malfunction
Replace relief valve
Refer to the windrower
operator
’
s manual
Cutting tough crops with standard
torque (19-tooth) reel drive sprocket
Replace with high torque (10-tooth) or
14-tooth reel drive sprocket
Optional Reel Drive Sprockets, page 58
Symptom: Plastic Fingers Cut at Tip
Insufficient reel to cutterbar clearance
Increase clearance
5.8.1 Reel Clearance to Cutterbar,
page 202
Symptom: Plastic Fingers Bent Rearward at Tip
Reel digging into ground with reel
speed slower than ground speed
Raise header
Reel digging into ground with reel
speed slower than ground speed
Decrease header tilt
Controlling Header Angle, page 57
Reel digging into ground with reel
speed slower than ground speed
Move reel aft
3.7.11 Reel Fore-Aft Position, page 61
Symptom: Plastic Fingers Bent Forward at Tip (Opposite of Above)
Reel digging into ground with reel
speed faster than ground speed
Raise header
Reel digging into ground with reel
speed faster than ground speed
Decrease header tilt
Controlling Header Angle, page 57
Reel digging into ground with reel
speed faster than ground speed
Move reel aft
3.7.11 Reel Fore-Aft Position, page 61
Symptom: Plastic Fingers Bent Close to Tine Tube
Excessive plugging at cutterbar with
wads of crop accumulating at
cutterbar while maintaining reel
operation
Correct plugging/cutting issues
3.13 Unplugging Cutterbar, page 92
Excessive plugging at cutterbar with
wads of crop accumulating at
cutterbar while maintaining reel
operation
Stop reel before plugging becomes
excessive
—
Summary of Contents for D65
