26
SETTING ACTUATOR LIMITS
10
Once completely assembled, complete the
Reset Procedure
for the actuators,
using the remote controller, 11D. Ensure all actuators are completely retracted
with no errors once the procedure is complete.
Set the limits required in the following steps, using the
Inner and Outer Limits
Procedure.
The
“FORE AND AFT” actuators
operate in a linear motion, extending and
retracting the auger barrel from the header front.
The “RAISE AND LOWER” actuators operate in
a pivoting motion, lifting and
lowering the auger barrel relative to the header front.
To extend the actuators, press and hold the UP Arrow button.
To retract the actuators, press and hold the DOWN Arrow button.
11
Set the OUTER limit of the
“FORE AND AFT” actuators
just before maximum
extension.
To prevent an error occurring at maximum extension during operation.
12
Set the OUTER limit of the “RAISE AND LOWER”
actuators just before the end of
the curved slot in the bracketry is reached. Removing the bolt from the slot will
assist in visually determining this limit.
To prevent unnecessary loading on the actuator, possibly causing an error during
operation.
13
Set the Inner limit of the
“FORE AND AFT” actuators
just before contacting other
components of the header front such as the reel arm. Ensure to provide 10mm
clearance from other componentry minimum.
14
Set the inner limit of the “RAISE AND LOWER” actuators
ONLY if required, due to
contacting other header front componentry or identified as causing an
overloading error.
15
The limits of the actuators are now set and ready to use.
To save preferred positions within the limits set, follow the
Saved Positions
Procedure.