29
MSDD18-Li-2
In
more
detail
. . .
General operation / Care and maintenance
> Hold the product perpendicular to the screw to be screwed in/out. Holding it at an
angle may cause slipping or jamming of the driver bit.
> Place the tip of the driver bit directly on the screw first and then switch the product
on. Only apply as much pressure as necessary to keep the screw in place and the
driver bit in contact with the screw head. Too much pressure will cause damage to
the screw head and driver bit; too little pressure will cause the driver bit to slide away.
> Remove blocked and stuck screws by changing the rotational direction.
Care and maintenance
After use
> Switch the product off, remove the battery pack and let it cool down.
> Check, clean and store the product as described below.
The golden rules for care
WARNING!
Always switch the product off, remove the battery pack and let the
product cool down before performing inspection, maintenance and cleaning
work!
> Keep the product clean. Remove debris from it after each use and before storage.
> Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
> Inspect the product before each use for worn and damaged parts. Do not operate
it if you find broken and worn parts.
WARNING!
Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
General cleaning
> Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
> In particular clean the air vents after every use with a cloth and brush.
> Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
