23
MSDD18-Li-2
In
more
detail
. . .
Intended use / Product functions
Intended use
The product is intended for driving in and loosening screws as well as for drilling in wood,
metal, plastic. This product is not intended for impact drilling in brickwork/masonry. It
should not be used for working on materials that are dangerous to health. It must not
be used for tightening or loosening car wheel nuts.
For safety reasons it is essential to read the entire instruction manual before first operation
and to observe all the instructions therein.
Product functions
Switching ON/OFF (Fig. 8)
> Switch the product on by pressing the ON/OFF switch (6).
> Switch the product off by releasing the ON/OFF switch
(6).It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
WARNING!
Do not operate for long periods at low speed because excess heat
will be produced internally. When overload occurs, release the ON/OFF switch
immediately to avoid the motor overheating.
Forward / reverse rotation control
Change the rotational direction from forward to reverse by pressing the forward /
reverse rotation control (5).
WARNING!
Only change the rotational direction when the product is switched
off and has come to a complete stop! Always ensure that the forward / reverse
rotation control is adjusted to the correct position depending on the intended
operation!
Always push the forward / reverse rotation control as far as it will go! Do not
use the product with the control switch in any other position!
6
Fig. 8
