19
MSDD18-Li-2
Getting
Started . . .
WARNING!
Always use drill bits according to the intended use! For example,
never use a drill bit intended for working on wood for working on metal or vice
versa!
Observe the technical requirements of this product (see section Technical
specifications) when purchasing and using drill bits!
Some drill bits become hot during use! Handle them carefully! Wear protective
gloves when handling drill bits in order to avoid injuries like burns!
Inserting
> Turn the chuck sleeve (2) anticlockwise until the chuck jaws are opened wide enough
to insert the drill bit (Fig. 1).
> Insert the drill bit all the way to the stop (Fig. 2). If using a 25 mm driver bit, insert it
into the socket of a bit holder.
> Turn the chuck sleeve (2) clockwise until the drill bit is properly fastened in the chuck
jaws (Fig. 3).
2
Fig. 1
Fig. 2
Fig. 3
2
2
WARNING!
After short operation, switch the product off and check once again
that the bit is properly fastened! Caution, the bit could be hot!
Removing / Replacing
> Turn the chuck sleeve (2) anticlockwise until the chuck jaws are opened wide enough
to remove the bit.
> Remove the bit and insert a new one as described above if desired.
Before you start
