28
MSDD18-Li-2
In
more
detail
. . .
General operation
General operation
> Check the product, its battery pack and charger as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
> Double check that the accessories and attachments are properly fixed.
> Always hold the product on its handle. Keep the handle dry to ensure safe support.
> Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
> Switch the product off immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before
putting it down.
> Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
WARNING!
Keep in mind that there are buried objects hidden in every
household! Ensure that there are no gas, water or power lines hidden in the
working area that may be hit before operation – danger of electrical shock
and serious damage to people and property! Use a suitable detector to trace
such objects in advance!
Drilling
> Set the torque ring to drilling mode when drilling into wood, plastic or metal.
> Always hold the product perpendicular to the point to be drilled. Holding it at an angle
may cause slipping or jamming of the drill bit.
> Always place the drill tip directly on the point to be drilled first and then switch the
product on.
> Pre-drill larger holes with a small diameter drill bit first. Doing so makes drilling with
a larger diameter drill bit easier.
> Do not always drill at top speed. This unnecessarily increases the wear and tear of
the product and drill bit.
> Remove blocked and stuck drill bits by changing the rotational direction.
Drilling into plastic and metal
> Punch the drilling point before operation in order to avoid slipping of the drill.
> Use a metal drill bit for drilling into plastic and metal. Select a low speed and where
necessary use a cooling lubricant that is available at your specialist dealer.
Screw driving
> Set the torque ring to screw driving mode (numbers).
> Adjust the torque setting according to the screw size and workpiece material.
> Pre-drill the holes with a smaller diameter of the screw to be screwed.
