14
English
H
FIG. 7
C
Anvil with Hog Ring
(Fig. 2, 7)
WARNING:
Use only impact accessories.
Non-impact accessories may break and cause a
hazardous condition. Inspect accessories prior to
use to ensure that it con tains no cracks.
Place the forward/reverse button (B) in the locked
off (center) position or remove battery pack
before changing accessories.
CAUTION:
Inspect anvils and hog rings prior to use. Missing or
damaged items should be replaced before use. Place the switch in the
locked off (center) position or remove battery pack before changing
accessories.
To install a accessory on the hog ring anvil,
firmly push accessory
onto the anvil (C). The hog ring (H) compresses to allow the accessory
to slide on. After the accessory is installed, the hog ring applies
pressure to help provide accessory retention.
To remove a accessory,
grasp the accessory and firmly pull it off.
MAINTENANCE
CAUTION:
Ensure fastener and/or system will withstand the level of
torque generated by the tool. Excessive torque may cause breakage
and possible personal injury.
1. Place the socket on the fastener head. Keep the tool pointed
straight at the fastener.
2. Press switch to start operation. Always check torque with a
torque wrench, as the fastening torque is affected by many factors
including the following:
•
Voltage:
Low voltage, due to a nearly discharged battery, will
reduce fastening torque.
•
Socket size:
Failure to use the correct socket size will cause a
reduction in fastening torque.
•
Bolt Size:
Larger bolt diameters generally require higher
fastening torque. Fastening torque will also vary according to
length, grade, and torque coefficient.
•
Bolt:
Ensure that all threads are free of rust and other debris to
allow proper fastening torque.
•
Material:
The type of material and surface finish of the material
will affect fastening torque.
•
Fastening Time:
Longer fasten ing time results in increased
fastening torque. Using a longer fastening time than recom-
mended could cause the fasteners to be overstressed, stripped
or damaged.
SPECIFICATIONS
Model #
Square
Drive
Max Breakaway Torque
Noise Level
in
ft-lbs / Nm
Pressure dB(A)
Power dB(A)
BWP151
1/2"
1200 / 1627
104
3
115
3
Vibration Level
Blow Rate
Free Speed
Weight
m/s
2
bpm
rpm
lbs / kg
13
5.9
2400
400 / 1200 / 1900
5.8 / 2.6
* = measurement uncertainty in dB(A) ** = measurement uncertainty in m/s²