Ingeniería de Servicio
- 61 -
Service Mode Tests
Knob Index / Test
number (Displayed
on SSD, 7-segment
display, if present)
(Without SSD will
be displayed in
binary format. (See
Binary Chart)
Test Name
Description of test
If tests call for numbers to be shown it will:
(Display on SSD, 7-segment display, if present)
(Without SSD will be displayed in binary format.
(See Binary Chart) Turning the cycle knob will
index to the next or prior test.
12
Drain Pump
Pressing
Start
will toggle the drain pump on and
off.
Test will have a timeout (4 minute) for how long
drain pump will be on.
The drain pump will turn off when the test is
exited.
14
Spin
Pressing
Start
will start the test. Spin test will
perform child safety algorithm before it starts to
spin. (Two (2) sprays of water before locking the
lid). The lid must be closed to start the test. If lid
is opened the
Locked
LED will blink.
When started, the mode shift to spin will occur if
required and the lid will be locked.
When mode shift is complete, the washer will
begin spinning to max spin speed for the model
being tested.
Spin test will have a timeout (4 minute).
Be sure to only run this test with an empty basket
as there is no OOB detection during this test.
The spin will stop when the test is exited.
The lid will unlock once the speed reaches 0 after
the test is exited.
Summary of Contents for Kraken
