24
Hakki Pilke 38 Easy
Original
Version 6
5.1.2.
Replacing the blade flange
Replace the blade flange as follows:
1. Remove the blade chain according to steps
1–6 of Section 5.1.1.
2. Remove flange bolts (2 pcs) and remove
the flange fastening plate A.
3.
Remove the flange from the groove.
4.
Place the new flange against the gear
wheel B, twist it into the groove and
loosely attach the flange bolts and the
fastening plate A.
5.
Install and tighten the blade chain
according to steps 7–9 of Section 5.1.1.
Figure 28.
5.2.
Replacing and tightening the V-belts
Replace the V-belts as follows:
1.
Shut down the splitter and
disconnect it from its power
sources.
2.
If necessary, slide the cover of
the
socket
and
angle
transmission into a position
where the angle transmission is
visible.
3.
Remove the cover of the
sawdust box A (Figure 29) by
removing the fastening bolts (2
pcs).
4.
Remove the lifting pins (2 pcs)
and the fastening bolts of the
rear cover (6 bolts in Figure 31
and 1 bolt next to the electrical
connector) of the machine and
remove the cover plate B.
5.
Remove the cover C of the V-
belts by removing the fastening
bolts (2 pcs) in the figure.
Figure 29. Figure 30.
Figure 31
