KS2V2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-3608 Rev.9 P. 3 / 9
COMPONENT IDENTIFICATION
A. Measured Value (PV) /
Alarm SET1 Display
B. Measured Value (PV)
Indicator LED
D. SELECT Key
C. Alarm SET2 / Parameter Display
J. Alarm SET2 Indicator LED
H. Alarm SET1 Indicator LED
G. Power Indicator LED
F. DOWN Key
E. UP Key
Ref.
Component Name
Function
A
Measured Value (PV) / Alarm SET1 Display Displaying either of Measured Value (PV) or Alarm Setpoint Value (SET1)
B
Measured Value (PV) Indicator LED
LED turns on when the Measured Value (PV) is displayed.
C
Alarm SET2 / Parameter Display
Displaying either of Alarm Setpoint Value (SET2) or parameter type code.
D
SELECT Key
Used for confirming current setpoints and switching between parameter
blocks.
E
UP Key
Pressing the key increases display values.
They change continuously when it is kept pressed.
F
DOWN Key
Pressing the key decreases display values.
They change continuously when it is kept pressed.
G
Power Indicator LED
LED turns on while the power is turned on.
H
Alarm SET1 Indicator LED
LED turns on when the Alarm SET1 is in tripped conditions.
I
Alarm SET2 Indicator LED
LED turns on when the Alarm SET2 is in tripped conditions.
PREPARING POWER-UP
When the power is turned on, the unit displays all segments
on the Measured Value (PV)/Alarm Setpoint Value (SET1)
Display and on the Alarm Setpoint Value (SET2)/Parameter
Display before starting operation.
To ensure a proper operation of the unit, set the parameters
before starting up according to the operating conditions.
Be sure to remove power of the final control element before
parameters setting.
Wait for 10 minutes for warming up the unit before its tem-
perature is stabilized and measuring is started.
HOW TO SET PARAMETERS
■
CONFIRMING CURRENT MEASURED VALUE AND
ALARM SETPOINT VALUES
Pressing SEL key turns the display in order of SET1, SET2,
PV, and blank.
Key
Status or Operation
Display
Current display
(PTn = 1 in this example)*
2
Display pattern 1
Upper = ST1 (setpoint)
Lower = ST2 (setpoint)
SEL
Press the key once.
Display pattern 2
Upper = PV (value)
Lower = blank
SEL
Press the key once.
Display pattern 3
Upper = blank
Lower = blank
SEL
Press the key once.
Returning to Display
pattern 1
*2. Which display pattern is to be displayed first after the
power is turned on can be programmed in Parameter block
1.
■
REGISTERING SETTING
1) Data is registered automatically in 3 seconds after the
data is set. Pressing SEL key also register the data.
2) The display automatically returns to the display pattern
preset by PTn parameter when the unit is left for approx.
30 seconds with no access.
