KS2V2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-3608 Rev.9 P. 2 / 9
■
KEY OPERATION AND OPERATION IN ABNORMALITIES
1) Prior to operation, test alarm functions to confirm correct
alarm mode setting.
2) When the input wires are broken, the unit displays
LLLL. Be sure to turn off the power supply before re-
placing the sensor.
■
OTHERS
1) Do not use organic solvents such as alcohol or benzine to
clean the unit. Use a neutral detergent.
TERMINAL CONNECTIONS
Connect the unit as in the diagram below.
■
EXTERNAL DIMENSIONS unit: mm (inch)
5
6
7
8
2
1
11
10
3
9
4
[3.5] (.14)
110 (4.33)
7.5
(.3)
48 (1.89)
48 (1.89)
t
1 ≤ t ≤ 8
(.04 ≤ t ≤.31)
MOUNTING
BRACKET
71.5 (2.81)
70 (2.76)
40 (1.57)
50 (1.97)
7.8 (.31)
CLAMP
(top & bottom)
DIN RAIL
35mm wide
2–4.5 (.18) dia.
MTG HOLE
25 (.98) deep
1 1–M3.5
SCREW
PACKING
7 (.28)
PANEL
1.5 (.06)
■
CONNECTION DIAGRAM
7
8
10
11
9
2
3
1
N.C.
N.O.
COM
SET1
N.C.
N.O.
COM
SET2
U(+)
V(–)
POWER
+
–
INPUT
5
6
■
PANEL CUTOUT unit: mm
45
45
+0.5
0
+0.5 0
85 MIN.
63 MIN.
INSTALLATION
Detach the yellow clamps located at the top and bottom of the unit for separate the body from the base socket.
■
DIN RAIL MOUNTING
Set the base socket so that its
DIN rail adaptor is at the bot-
tom. Position the upper hook
at the rear side of base socket
on the DIN rail and push in
the lower. When removing the
socket, push down the DIN
rail adaptor utilizing a minus
screwdriver and pull.
■
WALL MOUNTING
Refer to “EXTERNAL DI-
MENSIONS.”
■
HOW TO MOUNT THE UNIT ON A PANEL
The watertight packing must be in place to hold the unit.
Do not remove it.
1) Insert the unit into the panel cutout.
2) Push the mounting brackets into the grooves on both
sides of the rear module, until they hit the panel’s rear
side.
Mounting Bracket
Watertight packing
Panel
Clamp
(top & bottom)
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
Shape and size of the base socket
are slightly different with various
socket types.
