6
this area is necessary to ensure sufficient fresh air.
2.6
INSTALLATION THE FIREPLACE MODEL SERIES „RD“ ON THE PLACE OF USE
Fireplace type series "LUNA HC" is installed in the heated or outside of heated space.
For the location of the fireplace insert type series "RD" in the heated space, the operator must decide
whether to implement the distribution of heated air or not. If the operator decides that yes, it is necessary to
ensure the distribution of heated air from the space garnishment fireplace insert type series "RD", but in this case
will not be so intense airflow. If the operator decides that no heated air is to be exported from the area Converted
fireplace insert with hot air diffusers, in order to ensure air circulation.
2.7
LOCATION OF THE FIREPLACE STOVE
FIREPLACE INSERT SHOULD NOT BE LAID ON THE FLOOR DUE TO THE NATURAL
FLOW OF AIR. MINIMUM DOSTANCE BETWEEN THE FLOOR AND THE STOVE IS 2 CM.
AIR-INLET OPEN/ ALSO FOR EXTERNAL AIR INLET/ IS LOCATED AT THE BACK SIDE
DOWN OF THE FIREPLACE STOVE. /SEE PIC.6/
Setting up the high of fireplace insert can be in two ways:
1 -
to do a special higher floor or to use steel construction
2 -
soft setting with a set screw M16 cca.50mm /see Pic.1/
2.8 ISOLATION AND SURROUND
FOLLOW THESE INSTRUCTIONS. IF YOU DO NOT FOLLOW THE
INSTRUCTIONS QUIPMENT MAY OVERHEAT.
Once the installation is completed, the stove can be surrounded. If everything was checked, it is possible
to do final insulating and finishing work.
Make sure the device is not put too tight and that there is
adequate space for the flow of hot air.
We suggest that you use for insulation insulating plates
the
thermal resistance of more than 400 C. It is forbidden to use f
lammable materials like insulation materials.
Very important point from installation is the distance, which have to be between fireplaces and building
materials such as marble...
min 5 mm.
This expansion space is used to compensate for thermal expansion of the
fireplace insert body and its parts on heating and cooling.
Obr.č.8
Pic.6
