JS-MD 1C Aircraft Flight Manual
MD01-AFM-00-001
Issue: 02
Rev. 00
Rev. Date: 14.09.2017
Page 4–10
6.
Check that the CG hook manual and automatic operation works
properly. Accumulated dirt or mud may lead to improper
functioning of the release hook.
7.
Check that the water drain orifice behind the landing gear box is
clear.
Wings
1.
General condition - check for evidence of damage to the surface
finish or structural damage, pressure marks and cracks.
2.
Check that the water drain orifices at the wing root and tip are
clear.
3.
Check the airbrakes for functioning and locking. Check for water
or foreign objects in the airbrake boxes.
4.
Check that the outer wing panel is properly locked without play.
5.
Check that the flaperons move freely with no hinge play. Perform
a positive control check on the inboard and outboard flap.
6.
Check that wing tip wheels are in good condition – the clearance
between the flap trailing edge and the ground in positive flap with
maximum aileron deflection must be at least 10 mm. Check that
wheels are attached positively to the wing.
7.
Check that control surface gap seals are installed and properly
adhered to the wing recesses.
8.
Check that the NACA ducts on the lower surface of the flaperons
are clear.
9.
If the bug wiper system is installed, perform the checks given in
section 7.14.3.
10. If flying with water ballast:
•
Check before filling if all the rubber seals on the dump valves
are in position, and that all valves are operating correctly.
4