Page 17 of 44
©2018 Lytx, Inc. - Confidential & Proprietary.
Attach the Bracket and Window Unit
CAUTION: The adhesive is very sticky. Once applied, it will not easily come off. Take care
to attach the bracket to the mounting location properly.
CAUTION: Do not apply excessive pressure as it may cause the windshield to break.
1. Remove the backing from the adhesive side of
the bracket.
2. Carefully attach the bracket to the windshield.
a. Place the top edge of the bracket against
the windshield, aligned with the marks,
and make sure it is level.
b. Press the bracket firmly against the wind-
shield starting at the top and pressing the
sides downward. See Figures A and B.
3. Check from outside the vehicle for large air
bubbles under the bracket. If you find any:
a. Apply additional pressure to the bracket.
b. Slide a pin between the bracket and wind-
shield to let out the air.
4. Wait 10 minutes to allow the bracket's adhesive to bond.
5. Place the Window Unit in the bracket.
6. Adjust the Window Unit so it hangs vertically (plumb). See
Figure C.
7. Secure the Window Unit in the bracket using the two T-27
Torx screws.
IV. Connect Electrical Wiring
Connecting the electrical wiring consists of these subsections:
Electrical Connection Overview Diagram
Wiring and Wire Termination Suggestions
Basic Event Recorder Electrical Connections
